Front Sway Bar End Link Installation

The rubber bushings separate the lca and bar ends.

Front sway bar end link installation.

Sway bar end links have undergone a design change as front suspension design has transformed. Using your floor or scissor jack install it underneath the lower control arm on the other side and raise it slightly. Bolt style moog bolt style sway bar links feature problem solving innovations for longer life and easier installation features unique bushings that are molded to center the coated washers into place making it easier to install uses a 1 barrel lock nut that can easily be threaded on even if the bolt end is flush with the washer. Do not fully tighten the end link.

The switch to macpherson struts required a change in how and where sway bar end links were connected. Video tutorial on how to replace a sway bar link. In the situation the center bolt broke on the other side therefore both are being replaced. Sway bar end links.

Sway bar end link length question help. In the case tha. Sway bar link replacement ford explorer. Classic mustang specific tech.

This part is an oe replacement and comes with two mounting nuts. You may have to use a pry bar and lift or move the suspension a bit to get the new links to align properly in their right place. In most cars a sway bar link has two small ball joints at each end. Over time the sway bar link ball joints wear out.

Position the new sway bar links in place. The part that connects the outer ends of the sway bar to the suspension component is called a sway bar link. 2005 2010 mustang ford front sway bar end link this front sway bar end link from ford will fit all 2005 2010 mustangs. Learn how to replace the sway bar end links on a ford ranger ford mustang mazda b series truck ford explorer for.

The washers support the bushings so they don t tear when compressed against the bolt and or nut the first side end link install will be pretty easy. Sn95 4 6l mustang tech. Front sway bar end link bushings look bunched squished on install. Sway bar end link replacement.

Classic mustang specific tech. While the front sway bar on your 2005 2010 mustang isn t a wearable item the end links do require replacement since the ball and socket joints will wear. Normally the bushings will wear out over time but in this scenario the center bolt broke. Tighten down on the links one at a time.

Confusing the matter even more they connect upward to the macpherson strut and are longer or they connect to the lower control arm and are shorter. Place your new end link into the sway bar and shock mount in the same manner as the oem end link. Install the top end link nut onto the end link using a 19mm wrench while keeping the end link from spinning by using an 8mm wrench on the back of the end link.