Either side of the checkering guide head since the sides are at a 90 angle to the front strap.
Front strap checkering jig.
I lay a 1 2 steel rod in the inside of the frame measure with calipers and then subtract 0 50 from this measurement.
1911 back strap metal msh only 85 00.
Clamps to any single stack govt.
Integrity arms nov 16 2018 integrity arms nov 16 2018.
Checkering the front strap of a 1911.
Length frame and provides repeatable indexing for vertical and horizontal cuts plus the initial undercut.
The front strap needs to be trued before starting the job.
Produces accurate beautiful hand cut checkering in any lpi spacing.
This will help me make the stop line for the checkering.
Sets up 60 or 90 diamonds.
I understand this is not mandatory with every checkering job but it was highly recommended to me so that is what i did.
I updated my 1911 checkering jig.
1911 front strap 20 lpi 125 00.
He has specs on the page for round stock that you can purchase to practice on that is roughly the same size as a 1911 front strap.
Print this to be sturdy.
To clean up and sharpen the diamonds and probably some sort of jig to help you make straight lines and a good.
1911 back strap 25 lpi.
I used a smooth 8in file to do this.
You may have.
Clamps over the frame of a 1911 auto to provide a solid guide for getting the front strap checkering lines started correctly.
First check the thickness of the metal on the front strap of the frame.
By oddjob april 23 2006 in general.
Government or commander models.
To start with the frame has to be stripped down to nothing.
The stl files are oriented for the best 1911 fitting print.
There are high and low spots that can be smoothed out.
Long enough to allow a good long contour following stroke on the checkering file.
Get true diamonds on front strap.
Professional quality fixture helps you produce straight accurate front strap frame checkering on your very first try.
Scopes scope bases scopes scope base.
The new jig is larger and has a wider guide area.
I don t bother to take off the plunger tube or grip bushings.
1911 front strap 25 lpi.
The strap might look straight but you may find it is far from it.
The horizontal jig will need supports to hold the shelf up but they are very easy to remove.
Then i tie wrap the top of the strap as high as i can get it without it starting up the curve of the trigger guard.
And the best part it s a 406 radius lol started at 1 2 and front strap is a bit thin but these are practice frames so checkering will have to be 25lpi.
If you wish to actually checker the front strap the 60 angle on the front of the guide s head will position the master lines properly.
I have also added a jig to help with the vertical lines too.
1911 back strap 20 lpi.
